Telnet Connection - SMC Networks SMC TigerStack III SMC6824M Management Manual

U C
SING THE OMMAND
After connecting to the system through the console port, the login screen
displays:
User Access Verification
Username: admin
Password:
CLI session with the SMC6824M is opened.
To end the CLI session, enter [Exit].
Console#

Telnet Connection

Telnet operates over the IP transport protocol. In this environment, your
management station and any network device you want to manage over the
network must have a valid IP address. Valid IP addresses consist of four
numbers, 0 to 255, separated by periods. Each address consists of a network
portion and host portion. For example, the IP address assigned to this
switch, 10.1.0.1, consists of a network portion (10.1.0) and a host portion (1).
Note: The IP address for this switch is obtained via DHCP by default.
To access the switch through a Telnet session, you must first set the IP
address for the switch, and set the default gateway if you are managing the
switch from a different IP subnet. For example,
Console(config)#interface vlan 1
Console(config-if)#ip address 10.1.0.1 255.255.255.0
Console(config-if)#exit
Console(config)#ip default-gateway 10.1.0.254
If your corporate network is connected to another network outside your
office or to the Internet, you need to apply for a registered IP address.
However, if you are attached to an isolated network, then you can use any IP
address that matches the network segment to which you are attached.
4-2
L I
INE NTERFACE