Modulator Unit
Removal/lnstallation
CAUTION:
. Do not spill brake fluid on the car; it may damage the paint; if brake fluid does contact the paint, wash it off immedi-
ately with water.
. Take care not to damage or deform the brake lines during lemoval and installation.
. To Drevent the brake fluid from flowing, plug and cover the hose ends and ioints with . shop towal or equivalent
material.
NOTE: Tighten the flare nuts to 15 N.m ( 1.5 kgf m, 1 1 lbf'ft).
Removal
1. Disconnect the modulator unit 10P and pump motor 2P connectors
2.
Disconnect the brake lines, then remove the modulator unit
lnstallation
1. Install the modulator unit, then connect the brake lines.
2.
Connect the modulator unit
'l0P and pump motor 2P connectors
3.
Bleed the brake system.
4.
Start the engine, and check that the ABS indicator light goes off.
PUMP MOTOR
2P CONNECTOR
ffi
t '
TOR UNIT
'%
1 9 - 6 3