Honda Civic 1998 Service Manual page 661

Linear Solenoids/lnhibitor Solenoid
Test
2 .
'L
Disconnect the 8P connector from the solenoid har-
ness conneclor.
M e a s u r e t h e r e s i s t a n c e o f t h e s h i f t c o n t r o l l i n e a r
solenoid between the No. 3 and No. 7 terminals of
the solenoid harness connector.
lMeasure the resistance of the PH-PL control linear
solenoid between the No. 2 and No. 6 terminals.
Measure the resistance of the start clutch control
linear solenoid between the No. 4 and No. 8 termi-
n a l s .
STANDARD: 3.8 - 6.8 o
M e a s u r e t h e r e s i s t a n c e o f t h e i n h i b i t o r s o l e n o i d
between the No. 5 terminal and body ground.
STANDARD: 11.7 - 21.0 0
3.
SOLENOID HARNESS
CONNECTOR
ATF DIPSTICK
6.
Replace the lower valve body assembly if any of the
solenoids resistance is beyond the standard.
14-223
7. lf all of the resistances are within the standard, a
c l i c k i n g s o u n d s h o u l d b e h e a r d w h e n c o n n e c t i n g
the battery terminals to the solenoid harness con
nector terminals below:
. Shift control linear solenoid
No.3: Batterv positive terminal
No.7: Battery negative terminal
. PH-PL control linear solenoid
No.2: Bafterv oositive terminal
No.6: Battery negative terminal
. Start clutch control linear solenoid
No. 4: Batterv oositive terminal
No. 8: Battery negative terminal
. lnhibitor solenoid
No. 5: Battery positive terminal
Body ground: Battery negative terminal
SOLENOID HARNESS CONNECTOR
TERMINAL SIDE OF MALE TERMINALS
l f n o c l i c k i n g s o u n d i s h e a r d , r e p l a c e t h e l o w e r
valve body assembly.
N O T E | l f t h e l o w e r v a l v e b o d y a s s e m b l y r e p l a c e -
ment is required, see Lower Valve Body Assembly
Replacement {page'1 4-234).
8.