Honda Civic 1998 Service Manual page 905

Doors
1 .
Latch Replacement
NOTE: Raise the glass fully.
Remove:
.
Door panel (see page 20-4)
.
Plastic cover (see page 20-21
. Outer handle (see page 20-5)
Remove the bolt, then move the center lower channel
forward.
3.
Disconnect the connector, and detach the harness
c l i p f r o m t h e d o o r . R e m o v e t h e l a t c h t h r o u g h t h e
hole in the door.
NOTE: Take care not to bend the inner handle rod,
outer handle rod, cylinder rod and lock rod.
>: Screw locations,3
2 .
6 x 1 . 0 m m
I N.m {0.8 kgf.m,
6 tbf.ft)
NOTE:
. M a k e s u r e t h e i n n e r h a n d l e
are connected properly.
. lvlake sure the door locks and
20-6
4.
Installation is the reverse of the removal procedure.
rod and connector
opens properly.
LOCK ROD
' t .
Glass/Regulator Replacement
Remove:
. Door panel (see page 20-4)
. Plastic cover (see page 20-2)
Carefully move the glass until you can see the bolts,
t h e n r e m o v e t h e m . C a r e t u l l y p u l l t h e g l a s s o u t
through the window slot.
NOTE: Take care not to drop the glass inside the door.
>: Bolt locations. 2
GLASS
REGULATOR