Honda Civic 1998 Service Manual page 933

Rear Window
Installation (cont'd)
6. Glue the fasteners to the body as shown.
Fastener locations, 4
FASTENER
\ e l
4i< )
l Y l
F_L^NGE NycH,/,/
Set the rear window, then center it in the opening.
Make alignment marks across the rear window and
body with a grease pencil at the four points shown.
8. Remove the rear window.
1 .
ALIGNMENT MABK
S
20-34
I n ,
9 . W i t h a s p o n g e , a p p l y a l i g h t c o a t o f g l a s s p r i m e r
around the edge of the rear window as shown, then
lightly wipe it off with gauze or cheesecloth.
NOTE:
. Do not apply body primer to the rear window,
and do not get body and glass primer sponges
mixed up.
.
Never touch the primed surfaces with your hands.
lf you do, the adhesive may not bond to the rear
window properly, causing a leak after the rear
window is installed.
. Keep water, dust, and abrasive materials away
from the primed surface.
'//f
, appty gtass primer hera.
10 mm 10.39 in)
GLASS All around.
FASTENER
REAR WINDOW
10. With a sponge, apply a light coat of body primer to
t h e o r i g i n a l a d h e s i v e r e m a i n i n g a r o u n d t h e r e a r
window opening flange. Let the body primer dry for
at least 10 minutes.
NOTE:
. Do not apply glass primer to the body, and be care-
ful not to mix up glass and body primer sponges.
.
Never touch the primed surfaces with your hands.
''/fu7.
, oort, Aoa, orimer here.
1 6 m m
{0.63 inl
16 mm
7 m m
10.28 in)
t
I
MOLDING