Honda Civic 1998 Service Manual page 1009

Opener Cables
Opener and Latch
Replacement (cont'dl
Hatch/Fuel lid opener cable (3D):
NOTE: Bemove the following parts, then pull the carpet
back as necessary (see page 20-66).
. Rear seat cushion and rear seat-back {see page 20-80}
. Lower anchor bolt from the tront seat belt (see page
20-86)
. Side trim (see page 20-60)
. Spare tire lid
. Rear center shelf and rear side shelf (see page 20-60)
. Rear trim panel (see page 20-60)
. Side trim panel (see page 20-60)
>: Clip, c.ble cushion locations
A > , 9 D > , 5
B > , 1
c > , 1
* i
l
FUEL LID LATCH
(see page 20-112)
d o o
FUEL LID
OPENER
CABLE
--\,"
o / l
#)
Route the opener
cable through the
hole in the body.
STRIKER
HATCH
OPENER CABLE
HATCH/FUEL LID
OPENER
Installation is the reverse of the removai procedure.
NOTE:
.
N4ake sure each opener cable is routed and con
nected properly,
. Make sure the hatch and fuel lid open properly.
20-110
Replacement
NOTE: Take care not to bend the opener cables.
Hood release handle:
N O T E : R e m o v e t h e k i c k p a n e l ( s e e p a g e s 2 0 - 5 9 . 6 0 , 6 1 ) .
> : B o l l l o c a t i o n s , 2
|
I
6 x 1 . 0 m m i
9.8 N.m
I
HOOO OPENER
CABLE
{see page 20-108)
HOOD RELEASE
HANDLE
Hood latch:
NOTE: Remove the front bumper (see page 20-94).
Installation is the reverse of the removal procedure.
N O T E :
. Make sure the opener cable is connected properly.
. M a k e s u r e t h e h o o d o p e n s p r o p e r l y a n d l o c k s
securely.