Honda Civic 1998 Service Manual page 556

Inspection
. Clearance Measurement
NOTE: Lubricate all parts with ATF during assembly.
1.
Remove the mainshaft bearing from the transmis-
sion housing (see page l4-142).
2.
Assemble the parts below on the mainshaft.
NOTE: Do not assemble the O-rings during inspec-
tion.
LOCKNUT
CONICAL SPRING WASHER
SNAP RING
,I ST CLUTCH ASSEMELY
THRUST WASHEB
1ST GEAB COLLAR
TRANSMISSION
HOUSING BEARING
THRUST WASHER
4TH GEAR COLLAR
2ND/4TH CLUTCH
ASSEMBLY
THRUST WASHER
36.5 x 55 mm
Selective part.
TI{RUST NEEDLE
BEARING
2ND GEAR
NEEOLE BEARING
THRUST t{EEDLE
BEARING
MAINSHAFT
3. Torque the mainshaft locknut to 29 N'm (3.0 kgf'm,
22 lbf.ft).
NOTE: Mainshaft locknut has left-hand threads.
Hold 2nd gear against the 2nd clutch, then measure
the clearance between 2nd gear and 3rd gear with a
feeler gauge.
NOTE: Take measurements in at least three places,
and use the average as the actual clearance.
STANDARD: 0.05 - 0.13 mm {0.002 - 0.005 in)
(cont'd)
14 -1 17