Honda Civic 1998 Service Manual page 1092

Compressor
Clutch Overhaul (cont'd)
5.
Remove the screw from the field coil ground termi-
n a l , t h e n d i s c o n n e c t t h e f i e l d c o i l c o n n e c t o r .
R e m o v e s n a p r i n g A w i t h s n a p r i n g p l i e r s , t h e n
remove the field coil,
NOTE:
. Be careful not to damage the field coil and com-
pressor during remove/installation.
. Once snap ring A is removed, replace it with a
new one.
. When installing the field coil, align the boss on
the field coil with the hole in the compressor.
SNAP RING A
Replace.
6.
Position the rotor pulley squarely over the field coil.
Press the rotor pulley onto the compressor boss
w i t h t h e s p e c i a l t o o l . l f t h e r o t o r p u l l e y d o e s n o t
press on straight, remove it, and check the rotor
pulley and compressor boss for burrs or damage.
C A U T I O N : M a x i m u m p r e s s l o a d : 3 9 , 2 0 0 k P a
(400 kgt/cm', 5,690 psil
Preit
T
HUB ASSEMBLY
GUIDE ATTACHMENT
07965 - 6920500
FOTOR
PULLEY
-
22-32
7 . A s s e m b l e i n t h e r e v e r s e o r d e r o f d i s a s s e m b l y .
Make note of the following items.
. Install the field coil with the wire side facing down.
. C l e a n t h e r o t o r p u l l e y a n d c o m p r e s s o r s l i d i n g
surfaces with non-pet.oleum solvent,
.
Make sure the snap rings are fully seated in the
groove.
.
Make sure that the rotor pulley turns smoothly
after it's reassembled.
. Route and clamp the wires properly or they can
be damaged by the rotor pulley.