1T
Airbag
Disposal
Before scrapping any airbags (including those in a whole
vehicle to be scrapped), the airbags must be deployed. lf
the vehicle is still within the warranty period, before you
deploy the ai.bags, the Honda District Service Manager
must give approval and/or special instructions, Only after
the airbags have been deployed {as the result of vehicle
collision, tor example), can they be scrapped.
lf the airbags appear intact {not deployed), treat them
with extreme caution.
Follow this procedure:
Deploying the Airbags: In-vohicl€
NOTE: It an SRS vehicle is to be entirely scrspped, its
airbags should be deployed while still in the vehicle. The
airbags should not be considered as salvageable pans
and should never be installed in another vehicle.
! @
c o n f i r m t h a t e s c h a i r b a g a s s e m b l y i s
3.cursly mounted; otherwisg, soverg p€tsonal iniury
could result from doploymont.
l.
Disconnect the baftery negative cable, then discon-
nect the positive cable.
2.
Confirm that the special tool is tunctioning properly
by following the check procedure on the tool label
ot on page 24-7'l .
Driver's Airbag:
3.
Remove the access Danel, then disconnect the 2P
connecto. between the driver's airbag and the cable
reel.
DRIVER'S
AIRBAG
2P CONNECTOR
t'4-70
BATTERY
Front Pass€ngsr's Airbag:
4,
Remove the glove box, then disconnect the 2P con-
nector between the front passenger's airbag and
sRS main harness
FR.NT pAssENGER's
AIRBAG
SRS MAIN HARNESS
5.
Cut off the airbag connector, strip the ends of the
airbag wires, and connect the deployment tool alli-
gator clips to the airbag. Place the deployment tool
at least thirty teet (10 meters) away from the airbag,
DRIVER'S
AIRBAG
FRONT PASSENGER'S
AIRBAG