Honda Civic 1998 Service Manual page 790

14. Assemble a '12 x 1.25 mm flange nut onto a 12 x 175
mm grade 10 flange bolt as shown.
N O T E : W r a p t h e f l a n g e p o r t i o n o f t h e b o l t w i t h
vinyl tape to protect the cylinder.
I n s t a l l t h e f l a n g e b o l t i n t o t h e e n d o f t h e s t e e r i n g
r a c k u n t i l i t b o t t o m s i n t h e h o l e , t h e n b a c k t h e
f l a n g e b o l t o u t 1 / 4 t u r n . H o l d t h e f l a n g e b o l t , a n d
tighten the flange nut against the rack by hand.
Install the bearing separator on the gearbox housing
as shown.
'12 x 1t5 mm
Press
FLANGE BOLT
r-,,'
BEARING SEPARATOR
o - 4 1 1 2 " I
(commerciallv availablel
STEERING RACK
CYLINOER END SEAL
17. Set the gearbox in a press so the gear housing point
upward, then press the cylinder end seal and steer-
ing rack out of the gearbox.
NOTE: Hold the steering rack to keep it from falling
when pressed clear.
CAUTION:
. Be carelul not damage to inner surtace of the
cylinder housing with the tlange bolt.
. Do not place your lingers under the steering
rack.
tP/N 90177 - SLo - 0001
CYLINDER END SEAL
Repiace,
l " r
|
\s-,'
t " . .
I
t ^
I o-tfl
Q ) *
20. Insert a 24" lol
cial tool into th
N O T E : M a k e s
positioned on t
'18. Remove the l2 mm bolt and nut from the steering
rack.
1 9 . R e m o v e t h e c y l i n d e r e n d s e a l f r o m t h e s t e e r i n g
rack.
CYLINDER HOUSING
CAUTION: Be careful not damage to inner surtace
of the cylinder housing with the specialtool.
21. Set the gearbox in a press, then press out the cylin-
der end seal and backup ring from the gearbox.
CAUTION:
. Keep the tool straight to avoid damaging the cylin'
der wall. Check the tool angle, and correct it if nec-
essary, when removing the cylinder end seal.
. Use a press to rcmove the cylinder end seal. Do
not try to remove the seal by striking the tool. h
will break the backup ring, and the cylinder end
sealwill remain in the gearbox.
24 "LONG 3/8" DRIVE EXTENSIONI
{Commercially available)
BACKUP RING
CYLINDER ENO SEAL
the spe-
s r d e .
securely
long, 3/8" drive extension and
the cylinder from the gearbox
) sure that the special tool is
n the backup ring edges.
CYLINDER ENO SEAL
REMOVER ATTACHMENT
07NAO - SB3020A
(cont'd)
17-51
Press