Honda Civic 1998 Service Manual page 984

Front Seat Belt
1 .
2.
Replacement
CAUTION: Check the tront seat belts for damage, and
replace then if nacessary. B9 careful not to damage then
during removal and installation,
Fronl seat belt removal {,[D):
Slide the front seat forward fully.
Remove the center pillar lower trim panel (see page
20-59).
Remove the upper anchor cover and lower anchor
cap.
UPPER ANCHOR BOLT
7/16-20 UNF
32 N,m (3.3 kgf.m,
24 rbf.ftl
Apply liquid thread lock.
UPPER ANCHOR
COVER
FRONT SEA
BELT
RETRACTOR
MOUNTING BOLT
6 x 1 . 0 m m
9.8 N.m (1.0 kgf.m,
7.2 tbf.ftl
RETRACTOR
RETRACTOR BOLT
7/1&20 UNF
32 N.m (3.3 kgt.m,
2a tbtft)
LOWEN ANCHOR BOLT
7,/16-20 UNF
32 N.m (3.3 kgf.m, 24 lbf ftl
+
I
I
I
I
LOW
CAP
ER ANCHOR
Remove all the anchor bolts and the retractor bolt,
remove the retractor mounting bolt. then remove
the front seat belt and retractor.
6 .
Remove the center pillar upper trim (see page 20-59).
Remove the shoulder anchor adjuster.
I x 1.25 mm
23 N.m (2.3 kgf m,
17 tbf.ft)
ANCHOR
ADJUSTER
7.
Installation is the reverse of the removal procedure.
NOTE:
. Check that the retractor locking mechanism func-
tions as described on page 20-91.
. Make sure you assemble the washers and collars
on the uoDer and lower anchor bolts as shown.
. Before installing the anchor bolts, make sure there
are no twists or kinks in the front seat belt.
Upper anchor boh construqtion:
UPPER
ANCHOR
UPPER ANCHOR
BOLT
Apply liquid thread
COLLAR
(cont'd)
BEARING
20-85