a
From page 24 54
main harness; replace tha SRS
Chock lor a short to oower in tho SRS main harn€ss:
1. Disconnect the battery negative cable, then disconnect
the positive cable, and wait lor three minutes.
2. Disconnect the driv€r's airbag 2P connector from the
cable reel 2P connector.
3. Disconnect the SRS main harness 18P connector from
the SRS unit.
4. Remove the special tool (2 O) from the SRS main harness
2P connector,
5. Reconnect the battery oositive cable, then reconnect the
negative cable.
6. Connect a voltmeter between the No. 10 (+) terminal ol
SRS main harness 18P connector and ground.
7. Turn the ignition switch ON (ll), and measure voltage.
There should be 0.5 V or less.
L Connect a voltmeter between the No. 14 (+) terminal of
the SRS main harness 18P connector and ground, and
measure vohage. There should be 0.5 V or less.
SRS unit; rsDlace tho SRS unit (s€o page 24'76)
SRS UNIT
24-55