Honda Civic 1998 Service Manual page 514

Shift Control Solenoid Valve A/B Assembly
Test
1.
Disconnect the 2P connector from the shift control
solenoid valve A'lB assembly.
SHIFT CONTROL
SOLENOID VALVE A/8
ASSEMBLY
Measure the resistance between the No.
'1
terminal
(solenoid valve A) of the shift control solenoid valve
connector and body ground, and between the No. 2
terminal (solenoid valve B) and body ground
STANDARD: 12 - 25 O
Replace the shift control solenoid valve assembly if
the resistance is out of specification.
lf the resistance is within the standard, connect the
N o . 1 t e r m i n a l o f t h e s h i f t c o n t r o l s o l e n o i d v a l v e
connector to the battery positive terminal. A clicking
sound should be heard. Connect the No. 2 terminal
t o t h e b a t t e r y p o s i t i v e t e r m i n a l . A c l i c k i n g s o u n d
should be heard. Replace the shift control solenoid
valve assembly if no clicking sound is heard.
2,
Replacement
NOTE: Shift control solenoid valves A and B must be
removed/replaced as an assembly.
1. Remove the mounting bolts and shift control solenoid
valve 4!/B assembly.
6 x 1 . 0 m m
12 N.m
{1.2 ksl.m,8.7 lbt'ft}
CONNECTOR BRACKET
FILTER/GASKET
Replace.
Clean the mounting surface
and flu id passages.
2.
Clean the mounting surface and fluid passages of
t h e s h i f t c o n t r o l s o l e n o i d v a l v e a s s e m b l y , a n d
install a new shift control solenoid valve A,/B with a
new filter/gasket and the clamp bracket.
3.
Check the connector for rust, dirt or oil, and recon-
nect it securely.
14-75