Table of Contents
Advertisement
3-28
Operator Interface
Configure the Drive
7000A-UM151E-EN-P - October 2018
To abort the changes to the string being edited press the [backspace]
key. This will restore the string to its contents when the screen was
first entered.
The editing operation is completed by pressing the [enter] key.
Changes are not permanently made until the screen is exited via the
[F10] key.
Note: The characters entered may only be valid for the currently
selected language. Any characters used which are unique for a
given language (i.e. other than the four sets defined above) can only
be meaningfully displayed in the selected language, because other
languages do not contain the appropriate display characters.
In order to tailor the drive to your motor and application, a number
of elements must be defined in the drive. The section describes how
you will set or 'configure' these elements of the drive, via this
operator interface. You will learn how to:
Change a parameter setting.
Assign a parameter to an Analog Port.
Selectively enable or disable (i.e. Mask) certain faults.
Define your own faults attached to external inputs.
Configure the XIO
Define the information sent to your optional PLC connection.
Save and Restore your settings in the drive.
Select an alternate language (if previously loaded in operator
interface)
There are two methods to configure the drive. This section defines
the more complete method to configure the drive for any application.
The drive may also be configured for the majority of applications by
using the Setup Wizard. The Setup Wizard can be entered from the
"SETUP" screen by selecting the 'Setup Wizard' from the list of
options and pressing [enter].
Regardless of the method used for configuration, the default factory
parameters will be obtained from the Drive Identity Module (DIM).
The use of the DIM allows each drive to be customized at the factory
to the intended application, using all known information at the time
of building the drive.
Enter/Modify an Access Level
The drive is protected from unauthorized changes via passwords
consisting of a number between 0 and 65535. These passwords are
7000 "A" Frame
Advertisement
Table of Contents
