Table of Contents
Advertisement
Operator Interface
3-51
Figure 3.70 – Bit Description for Local Outputs
The DISPLAY screen, typical of Figure 3.68, is displayed. The
screen shows the name of the group being displayed to the right of
the screen name ("FEATURE SELECT"). One or more pages of the
members in the group are displayed along with the value for this tag
in the drive and its unit of measurement. Values that are bit encoded
will show a hex value for the parameter value. Use the up/down
cursor keys to select the parameter which is bit encoded and then
press the [enter] key (Figures 3.69 and 3.70). The VIEW
PARAMETER screen will then show that parameter as it is decoded
per bit as shown in Figure 3.70.
The left side of the pair shows the name of the bit, while the right
side shows the current value of the bit within the parameter.
All of these values are updated from the drive on a continual basis.
From the DISPLAY screen, it is possible to modify a parameter. If
the group you are currently viewing contains parameters, press the
[F7] key. The operator interface then allows you to select the
parameter you wish to modify. Refer to the section entitled "Modify
Parameters" for further details.
If you have modified any parameters in the drive, you will be
prompted to make the changes permanent. This prompt will occur
upon exiting the DISPLAY GROUP screen. Refer to "Message
Prompting" for further details.
Custom Group
From the DISPLAY GROUP screen (Figure 3.67) you can select a
group which you have custom defined by pressing the [F7] key. This
custom group contains selected tags from one or more other groups,
arranged by you onto a single screen for more convenient viewing
(Figure 3.71).
7000 "A" Frame
7000A-UM151E-EN-P - October 2018
Advertisement
Table of Contents
