Table of Contents
Advertisement
7000 "A" Frame
Modify Parameters
To change a parameter, Use the up/down arrow keys on the SETUP
screen to select the 'Parameters' option and press the [enter] key.
This will begin the selection process of a parameter as described in
the section entitled "Select a Parameter". The selection process to
change a parameter can also be initiated while displaying the
members of a parameter group on the DISPLAY screen (Figure 3.68)
by pressing the [F7] key.
When you have successfully selected a parameter, one of three
possible screens will be displayed depending on the type of
parameter.
Numerical Value
When the parameter is a numerical value, the MODIFY
PARAMETER screen typical of Figure 3.42 will be displayed. This
screen shows:
–
the name of the parameter for which you are making the changes
(i.e. Rated motor volt).
–
the tag code for the parameter, (i.e. 22).
–
the minimum and maximum allowable limits to which the
parameter must be set, (i.e. 4000 to 4160).
–
the units in which the parameter data is being displayed
–
the actual value of the parameter contained in the drive.
Figure 3.42 – Parameter Data Entry
Operator Interface
3-35
7000A-UM151E-EN-P - October 2018
Advertisement
Table of Contents
