Operator Interface
3-21
A screen typical of Figure 3.21 will be displayed. To modify the text refer
to the section entitled "Edit Text", noting the following exception. When
the text has been entered (as in Figure 3.22) the enter key has no effect.
Simply press the exit key [F10] to accept the edited string.
Prior to exiting the screen, the string can be returned to its state upon
entry to the screen by pressing the [F7] key.
Figure 3.21 – Edit the Drive Name
Figure 3.22 – Editing Completed
Transfer Data in Memory
The operator interface contains long term storage in two forms.
Flash memory contained in the operator interface is used to store the
firmware and optionally language modules and parameters used in
the drive. This information can also be stored on a removable flash
card that can be taken to another drive.
In order to transfer information from the two forms of memory, press
the [F7] key. This displays a new screen (Figure Error! Reference
source not found.) from which all flash memory operations are
performed. Refer to the section entitled "Flash Memory Transfers"
for instructions on these features.
7000 "A" Frame
7000A-UM151E-EN-P - October 2018