Table of Contents
Advertisement
2-16
Drive Installation
Cabling Cabinet #1
Control Power Transformer
Motor Cable Terminations
(Hall Effect Sensors behind)
Figure 2.11 – Cabling Cabinet for Configuration #1 with Input Starters
7000A-UM151E-EN-P - October 2018
The cabling cabinet of the drive with integral line reactor and input
starter is located in the left-hand section. The mounting and location
of the line reactor and input starter are shown along with customer
cable termination locations. The circulating fans for the cabinet are
located on top.
Note: This cabinet is also available without integral starter (see
Figure 2.13). The width of the cabinet changes as a function of the
drive voltage ratings.
Line Cable Terminations
(behind Disconnect Switch)
Fused Disconnect Switch
Disconnect Switch Operating Handle
Vacuum Contactor Assembly
Control Power Transformer Fuses
AC Line Reactor
7000 "A" Frame
Advertisement
Table of Contents
