Table of Contents
Advertisement
3-16
Operator Interface
7000A-UM151E-EN-P - October 2018
Figure 3.12 – Utility Contrast
Setting Time
The clock setting controls the time stamp that the drive uses on the
information contained on the alarm summary screen. To change the
time, press the [F5] key. The hour's position of the clock will be in
reverse video (Figure 3.13). Press the [cursor up] or [cursor down]
keys to change the value by a resolution of 1 unit. Press the [cursor
left] and [cursor right] keys to change the value by a resolution of 10
units. To change the minutes press the [F5] key again and repeat the
procedure. Likewise to change the seconds press the [F5] key again.
Each press of the [F5] key will highlight the next position of the clock.
The highlighted position may be modified via the cursor keys.
To abort the change, press the [backspace] key and the clock will
return to its original time. To accept the change, press the [enter]
key. The new clock setting has been recorded.
The setting may also be aborted by pressing any of the assigned
function keys (other than F1 and F5). The function associated with
that key will be executed.
Figure 3.13 – Utility Time
7000 "A" Frame
Advertisement
Table of Contents
