Table of Contents
Advertisement
3-40
Operator Interface
7000A-UM151E-EN-P - October 2018
Analog Ports
The drive contains a number of external analog ports to which you
can assign any parameter. To setup an analog port, use the up/down
arrow keys on the SETUP screen to select the 'Analog' option and
press the [enter] key.
This will display a series of screens as shown in Figure 3.49 . The
screen shows the current tags and their tag code, which are associated
with each of the analog ports. To change the tag attached to a port,
use the [cursor up] and [cursor down] keys to highlight the desired
port and press the [enter] key. (If nothing happens then you have not
gained the required access to make changes. Exit to the SETUP
screen and refer to the section entitled Enter/Modify an Access
Level to gain access).
7000 "A" Frame
Advertisement
Table of Contents
