Table of Contents
Advertisement
7000 "A" Frame
Save
The changes that you have made to the drive data must be saved if
you do not want to lose the data when the drive is powered off. To
save the changes, press the [F5] key (Figure 3.65).
Figure 3.65 – Save Operation
To confirm the operation, press the [F8] key to proceed, or the [F9]
key to abort. Saving the data will overwrite the previously stored
data in the NVRAM.
Load
The changes that you stored in NVRAM are automatically used each
time the drive is powered up. If you make changes to the data in the
drive (without saving) and then wish to use the previously stored
data, press the [F4] key (Figure 3.66).
Figure 3.66 – Load Operation
To confirm the operation, press the [F8] key to proceed, or the [F9]
key to abort. Loading the data will overwrite the data currently
being used by the drive.
Operator Interface
3-49
7000A-UM151E-EN-P - October 2018
Advertisement
Table of Contents
