Table of Contents
Advertisement
3-62
Operator Interface
Loading Language Modules
7000A-UM151E-EN-P - October 2018
In order to use a language in the operator interface, it must first be
loaded into the operator interface from the flash card.
From the TRANSFER screen, press the [F5] key. The operator
interface will enter the DIRECTORY screen, from which an existing
language module filename can be selected or entered, Figure 3.83.
Refer to the sections entitled "Select a filename" and "Enter a
filename". (If nothing happens then you have not gained the required
access to modify the flash memory. Exit to the TRANSFER screen
and refer to the section entitled Enter/Modify an Access Level to
gain access).
When the filename has been obtained, the TRANSFER:
LANGUAGE screen such as that in Figure 3.84 will be displayed,
showing the filename, indicating the operation you are about to
perform and showing the current status of the operation.
Figure 3.83 – Language Directory
Figure 3.84 – Transfer Language Module
The screen will then ask you to confirm the operation. Press the [F8]
key to proceed, or the [F9] key to abort. If an attempt to download a
language module that already exists is made, the transfer will fail.
7000 "A" Frame
Advertisement
Table of Contents
