Table of Contents
Advertisement
1-4
Overview of Drive
Rectifier Designs
7000A-UM151E-EN-P - October 2018
Active Front-End (AFE) Rectifier
An Active Front-End rectifier is particularly attractive since it does
not require an isolation transformer to meet IEEE 519-1992.
Many competing technologies in today's MV market require a multi-
winding transformer to mitigate the unwanted harmonics through
cancellation by phase shifting the transformer secondary windings.
Depending on the topology, the transformer can have up to 15 sets of
secondary windings.
Elimination of the isolation transformer reduces capital and
installation costs, saves on valuable floor space, reduces
operating costs and increases overall system efficiency.
The AFE rectifier requires a switching pattern that complies with
similar rules as the inverter. The pattern used for the example shown
in Figure 1.3 is a 42-pulse selective harmonic elimination (SHE)
pattern, which eliminates the 5
input capacitors are designed to reduce the current harmonics of the
higher order.
The filter resonant frequency is placed below 300 Hz (for a 60 Hz
system) where no residual harmonics exist. This prevents the
excitation of system harmonic frequencies. Other factors that are
considered when designing the filter are the input power factor and
the requirement on Total Harmonic Distortion (THD) of input
current and voltage waveforms.
The small integral AC line reactor (see Fig. 1.2) provides additional
filtering and current limiting features to a line side short circuit fault.
The line current and voltage waveforms are also shown in Figure 1.2.
The line current THD is approximately 4.5%, while line-to-line
voltage THD is approximately 1.5%. (THD of line voltage is a
function of system impedance.) Input power factor with the AFE
rectifier is near unity throughout a typical operating speed range for
variable torque loads.
th
th
th
, 7
and 11
harmonics. The integral
7000 "A" Frame
Advertisement
Table of Contents
