Table of Contents
Advertisement
7000 "A" Frame
Enumerated Value
When the parameter is an enumerated value, the MODIFY
PARAMETER screen typical of Figure 3.44 will be displayed. This
screen shows:
•
the name of the parameter for which you are make the changes
(i.e. Operating Mode)
•
the tag code for the parameter (i.e. 4)
•
the actual value of the parameter contained in the drive.
Figure 3.44 – Modify Enumerated Value
Figure 3.45 – Option List Viewed on Single Page
To be allowed to make changes to the parameter, the operator
interface must be set to an Access Level other than 'Monitor'. (You
will be able to view the screen; however, pressing the data entry keys
will have no effect). If you are not in the correct level, press the [F8]
key in order to gain access to the parameter. Refer to the section
entitled Enter/Modify an Access Level for further information on
the operation to change the level.
Having gained access, press the up or down cursor keys to obtain a
list of possible options to select from. Use the up/down arrow keys
to move the highlighting to the desired option (Figure 3.45). If more
Operator Interface
3-37
7000A-UM151E-EN-P - October 2018
Advertisement
Table of Contents
