Table of Contents
Advertisement
4-56
Component Definition and Maintenance
Environmental
Consideration
(cont.)
7000A-UM151E-EN-P - October 2018
•
Capacitor Dielectric Fluid
The fluids used in the filter capacitors and the snubber capacitors are
generally considered very safe and are fully sealed within the
capacitor housings. Shipping and handling of this fluid is not
restricted under any regulations. In the unlikely event that capacitor
fluid leaks out, avoid ingestion or contact with skin or eyes as slight
irritation could result. Rubber gloves are recommended for handling.
To clean up, soak into an absorbent material and discard into an
emergency container, or, if significant leakage occurs, pump fluid
directly into the container. Do not dispose into any drain or into the
environment in general or into general landfill refuse. Dispose of
according to local regulations. If disposing of an entire capacitor, the
same disposal precautions should be taken.
•
Printed Circuit Boards
Most of the printed circuit boards utilize lead-based solder. Shipping
and handling of these boards is not restricted under any regulations,
however, lead is considered a hazardous substance. Circuit boards
must be disposed of according to local regulations and must not be
disposed of with general landfill refuse.
•
Lithium Batteries
This drive contains one small 3V lithium battery on the DPM board.
The battery part # 346567-Q01 or BR2335 contains approximately
0.09 g of lithium metal. These batteries meet shipping regulations at
the time of publication, however there are specific marking and
packaging requirements. Properly packaged single, spare or expired
batteries may be shipped consigned as UN3090 PI 968 Part 1. A
maximum of two spare cells may be packaged with the DPM,
provided they are mechanically separated from each other during
shipment. Shipping cartons shall bear the warning: "Primary Lithium
Batteries – Forbidden for transport aboard passenger aircraft."
Lithium batteries must be disposed of according to local regulations
and must not be disposed of with general landfill refuse.
•
Chromate Plating
Some sheet steel and fasteners are plated with zinc and sealed with a
chromate-based dip (gold-colored finish). Shipping and handling of
chromate plated parts is not restricted under any regulations, however,
chromate is considered a hazardous substance. Chromate plated parts
must be disposed of according to local regulations and must not be
disposed of with general landfill refuse.
7000 "A" Frame
Advertisement
Table of Contents
