Table of Contents
Advertisement
3-48
Operator Interface
7000A-UM151E-EN-P - October 2018
Figure 3.62 – Message Prompt Screen
Figure 3.63 – NVRAM Screen
Store/Retrieve Configuration (NVRAM)
To access the memory functions, press [F5] on the Top Level Menu.
Within this screen it is possible to perform three operations on the
memory of the drive. To perform these operations you must have the
proper access to the drive. Refer to the section entitled
Enter/Modify an Access Level .
Initialize
The drive contains a default set of parameters and setup information.
This can form a basis for configuring the drive. To initialize the drive
with the default set of data, press the [F3] key. The screen will appear
as in Figure 3.64, indicating the operation you are about to perform.
The screen then will ask you to confirm the operation. Press the [F8]
key to proceed, or the [F9] key to abort. Performing an initialization
will overwrite the data currently in the drive. Previous changes that
were saved to NVRAM will not be affected.
Figure 3.64 – Initialize Operation
7000 "A" Frame
Advertisement
Table of Contents
