Table of Contents
Advertisement
7000 "A" Frame
The screen will then ask you to confirm the operation. Press the [F8]
key to proceed, or the [F9] key to abort. Pressing the [F4] key may
restart an aborted transfer or one that failed. To select or enter a
different filename, press the [F7] key.
Parameter File Format
The parameter file stored on the flash card is in a DOS file format.
This parameter file can be created off-line on a PC using any ASCII
text editor and then written to the memory card via a PCMCIA Card
Drive.
Information is this section is not needed to operate the operator
interface. It is required knowledge if you wish to create a parameter
file off-line and then download into a drive. The filename must have
the extension of *.PAR in order to be recognized as a parameter file.
The format of the file is as follows:
a) First Line:
–
a revision number followed by a semi-colon (;). Number is
not important.
–
the date followed by a semi-colon, i.e. 01/01/1996. Date is
not important.
–
the time followed by a semi-colon, i.e. 12:01:01. Time is not
important.
b) Remaining Lines:
–
each line contains one parameter. The line consists of the
linear parameter number followed by a semi-colon, and the
parameter value followed by a semi-colon. i.e.
1;0;
2;0;
5;2;
Operator Interface
3-61
7000A-UM151E-EN-P - October 2018
Advertisement
Table of Contents
