Table of Contents
Advertisement
4-14
Component Definition and Maintenance
SGCT captive screws
Temperature Sensing
7000A-UM151E-EN-P - October 2018
Never rotate the calibration nut located outside
I M P O R T A N T
I M P O R T A N T
the indicating washer at the end of the threaded
rod. The rotation of the outer nut will affect the
torque calibration, which is factory set. Only
adjust the inside nut. (See Figures 4.11 and 4.12.)
Disc springs
Figure 4.12 – Detail of the clamping assembly
Thermal sensors are located on heatsinks in the converter. The thermal
sensor is mounted on the heatsink with the temperature feedback board.
Clamp head block
DO NOT ADJUST outside nut.
Inside nut used for loosening
and applying load to assembly
7000 "A" Frame
Advertisement
Table of Contents
