Table of Contents
Advertisement
Configuration Using the Command Line Interface (CLI)
Rate Control
Switch(config-if)# rate-limit
egress
Rate Control
ingress
– Ingress or
Egress
Note: To enable rate control, you should select the Ingress or Egress rule first; then assign the
packet type and bandwidth.
Switch(config-if)# rate-limit ingress mode
all
broadcast
Rate Control
flooded-unicast
– Filter
Packet Type
multicast
Switch(config-if)# rate-limit ingress mode broadcast
Set the ingress limit mode broadcast ok.
Switch(config-if)# rate-limit ingress bandwidth
0
1024
128
2048
Rate Control
256
- Bandwidth
4096
512
8192
Switch(config-if)# rate-limit ingress bandwidth 8192
Set the ingress rate limit to 8192k for Port 1.
116 - Port Configuration (CLI)
Outgoing packets
Incoming packets
Limit all frames
Limit Broadcast frames
Limit Broadcast, Multicast and flooded unicast frames
Limit Broadcast and Multicast frames
0 is no limit
1024 is 1024Kbps
128 is 128Kbps
2048 is 2048Kbps
256 is 256Kbps
4096 is 4096Kbps
512 is 512Kbps
8192 is 8192Kbps
RocketLinx ES7506 User Guide: 2000529 Rev. F
Advertisement
Table of Contents
