Table of Contents
Advertisement
Configuration Using the Web Interface
Time Setting
Time Setting allows you to set the time manually or through a Network Time Protocol (NTP) server. NTP is
used to synchronize computer clocks on the internet. You can configure NTP settings here to synchronize the
clocks of several switches on the network. The ES7506 also provides Daylight Saving functionality.
Time Setting Page
Manual Setting: Click Manual Setting to change time as needed. You can also click the Get
Time from PC button to get PC's time setting for the ES7506.
Time Setting
NTP client: Click Time Setting Source if you want the NTP client to permit the ES7506 to
Source
enable the NTP client service. NTP client is automatically enabled if you change the
Time Setting Source to NTP Client. The system sends a request packet to acquire
current time from the NTP server you assign.
Select the time zone where the ES7506 is located. The following table lists the time
Timezone Setting
zones for different locations for your reference. The default time zone is (GMT)
Greenwich Mean Time.
Click the Daylight Saving Time check box and then set the Daylight Saving Time Start and
Daylight Saving
End times. During Daylight Saving Time, the ES7506 time is one hour earlier than the
Time
actual time.
Click Apply to apply the settings.
Apply
Note: You must Save the settings
46 - Time Setting
the ES7506 is powered off.
(Page
93), if you want to maintain these settings if
RocketLinx ES7506 User Guide: 2000529 Rev. F
Advertisement
Table of Contents
