Table of Contents
Advertisement
Configuration Using the Web Interface
IGMP Query
Use this page to configure the IGMP Query feature. Since the ES7506
can only be configured by member ports of the management VLAN, the
IGMP Query can only be enabled on the management VLAN. If you
want to run IGMP Snooping feature in several VLANs, first check to
see whether each VLAN has its own IGMP Querier.
The IGMP querier periodically sends query packets to all end-stations
on the LANs or VLANs that are connected to it. For networks with
more than one IGMP querier, a switch with the lowest IP address
becomes the IGMP querier.
IGMP Query Page
Version
Query Interval(s)
Query Maximum
Response Time
Apply
76 - IGMP Query
Select Version 1, Version 2 or Disable.
•
Version 1 means IGMP V1 General Query
•
Version 2 means IGMP V2 General Query. The query is forwarded to all
multicast groups in the VLAN.
•
Disable allows you to disable IGMP Query.
The period of query (seconds) sent by querier. Enter a number between 1
and 65,535.
The span querier detect (seconds) to confirm there are no more directly
connected group members on a LAN. Enter a number between 1 and 25.
Click Apply to apply the settings.
Note: You must Save the settings
settings if the ES7506 is powered off.
(Page
93), if you want to maintain these
RocketLinx ES7506 User Guide: 2000529 Rev. F
Advertisement
Table of Contents
