Table of Contents
Advertisement
Power Over Ethernet Control Page
Powering Mode
PoE Mode
Power Mode
Power Limit
PD Status Detection
PD Status Detection
IP Address
Cycle Time(s)
Apply
RocketLinx ES7506 User Guide: 2000529 Rev. F
Each port's ability to deliver power can be individually enabled or
disabled using the PoE Mode combo box. You can select 802.3af or
forced.
There are three power modes available for each port.
•
Standard mode delivers power following the IEEE 802.3af
specification.
•
Manual mode allows the user to specify the wattage limit
delivered to an IEEE 802.3af device.
•
Ultra mode should be used for IEEE802.3at power
requirements and allows the user to configure the wattage
limit above 15.4 watts.
Note: To deliver higher amounts of power the ES7506 must be
powered with a 55VDC power supply.
When delivering more than 15.4W of power, ensure the
ES7506 is mounted on panel capable of dissipating heat.
Also ensure the temperature where the ES7506 is located is
°
kept under 60
C. Delivering power above 15.4W causes the
ES7506 to generate more heat.
The limitation of the output power (watts) range is standard mode:
N/A, Manual mode: 0.44 - 15.4W, and Ultra mode: 0.44 - 30W.
Enable/Disable PD Status Detection function.
Type in the IP address that you want to detect.
This is the gap per detection in seconds.
Click Apply to apply the settings.
Note: You must Save the settings
these settings if the ES7506 is powered off.
Configuration Using the Web Interface
(Page
93), if you want maintain
PoE Control - 63
Advertisement
Table of Contents
