Table of Contents
Advertisement
Configuration Using the Command Line Interface (CLI)
User EXEC Mode
When you login to the ES7506 with the CLI, you are in User EXEC mode.
In User EXEC mode, you
can ping, telnet to a remote
device, and show some basic
information.
Type the command and
press Enter:
•
enable to access
Privileged EXEC mode
(Privileged EXEC Mode
on Page 102).
•
exit to logout.
•
? to see the command
list.
•
list to review the User EXEC mode commands and corresponding options.
For the complete list of commands with options, refer to
Accessing the Options for a Command
The following example illustrates how to view the description and options for a command. This example
illustrates the show command and the firmware version displayed may not reflect your firmware version.
Note: The ? does not appear on the screen.
1. If you type show? (without a space between show and the ?; do not press the Enter key) the ES7506
provides a basic description of that command.
Switch login: admin
Password:
Switch
switch> show
show
2. If you type show ? (with a space between show and the ?; do not press the Enter key) the ES7506 provides
information about the options for that command.
Switch> show
arp
ip
spanning-tree
version
Switch> show
3. Type show ip ? (with a space between show and the ?, do not press the Enter key) to review the options for
ip.
Switch> show ip
forwarding
route
100 - User EXEC Mode
Switch>
enable
exit
list
ping
quit
show
telnet
traceroute
(version 2.7 -20130314 - 15:23:41)
Show running system information
ARP table
IP information
Spanning-tree protocol
Displays ISS version
IP forwarding status
IP routing table
Turn on privileged mode command
Exit current mode and down to previous mode
Print command list
Send echo messages
Exit current mode and down to previous mode
Show running system information
Open a telnet connection
Trace route to destination
User EXEC Mode
RocketLinx ES7506 User Guide: 2000529 Rev. F
on Page 143.
Advertisement
Table of Contents
