Table of Contents
Advertisement
Configuration Using the Web Interface
DSCP-Queue Mapping
Use this page to change DSCP values to Physical Queue mapping table. Since the switch fabric of the ES7506
only supports four queues. Lowest, Low, Middle and High users should therefore assign how to map DSCP
values to the level of the physical queue. You should therefore assign how to map DSCP value to the level of
the queue. You can change the mapping table to follow the upper layer 3 switch or routers' DSCP setting.
After configuration, press Apply to enable the settings.
Note: You must Save the settings
(Page
93), if you want to maintain these settings if the ES7506 is powered off.
RocketLinx ES7506 User Guide: 2000529 Rev. F
DSCP-Queue Mapping - 73
Advertisement
Table of Contents
