Maintenance - GIRBAU HS-6008 Operation Instructions Manual

5. MAINTENANCE

- Before performing any work on the washing machine, disconnect and mechanically lock the
external switch, and close and mechanically lock the manual water inlet valves.
- Check the temperature of the parts to be handled, to avoid the risk of burns.
- The dispenser may contain residues of chemical products. When handling this component, avoid
direct contact with the skin and use eye protection.
The draining pump and valve may contain residual water. When handling these components,
-
avoid direct contact with the skin and use eye protection.
Remember to reassemble ALL of the panels and place them correctly after any maintenance work.
-
It is highly recommendable asking the Authorised Technical Service a register or report of all the
-
maintenance and service work done on your washer.
5.1. Operations described ...
•
Cleaning the washer (section 5.2)
•
Cleaning the door seal (section 5.3).
•
Cleaning the electro valve filters (section 5.4)
•
Cleaning the dispenser (section 5.5)
•
Cleaning the draining pump (models HS-6008/EH020 with pumped drain) (section 5.6)
5.2. Cleaning the washer
•
We recommend periodic cleaning of the outside of the washing machine. Use a damp cloth or sponge.
•
To remove traces of grease, use mild soap and rinse as required.
•
Never use abrasive products or tools that could scratch or damage the surface of the washing machine.
5.3. Cleaning the door seal
•
Use a damp cloth or sponge.
•
Be especially careful to remove traces of laundry products or pieces of fabric that could be caught
between the folds of the seal.
•
Never use abrasive products or tools that could cut or damage the seal.
5.4. Cleaning the electro valve filters
Required tools:
•
Disassembly of the fittings: Slip-joint pliers or pipe wrench diam. 1-½ in. (35 mm)
•
Disassembly of the filter supports: wrench 1-
•
Disassembly of the filters: pliers
Steps to follow
•
Disconnect and mechanically lock the external switch. Close and mechanically interlock the manual
water supply valves.
•
Check the temperature of the hot water inlet hose, so as to avoid the risk of burns.
•
Disassemble the fittings that connect the hoses to the washing machine.
•
Disassemble the filter supports (according to model).
•
Remove the filters from their housings and clean the filters with pressurised water. Place them back into
their housings.
•
Assemble the supports to the electrovalves (according to model).
•
Assemble the hoses in their corresponding inputs. Tighten the fittings.
•
Connect the external switch, open the manual water input valves and check the water tightness of the
coupling.
Maintenance
3
/ in. (34 mm)
8
21
Cod. 429266
Rev. 03/0209