Maintenance - GIRBAU HS-6013 Operation Instructions Manual

14. MAINTENANCE

- Before performing any work on the washing machine, disconnect and mechanically lock the
external switch, and close and mechanically lock the manual water inlet valves.
- Check the temperature of the parts to be handled, to avoid the risk of burns.
- The dispenser may contain residues of chemical products. When handling this component, avoid
direct contact with the skin and use eye protection.
- The draining pump and valve may contain residual water. When handling these components,
avoid direct contact with the skin and use eye protection.
Remember to reassemble ALL of the panels and place them correctly after any maintenance work.
-
14.1 Operations described
•
Cleaning the washer (section 14.2)
•
Cleaning the door seal (section 14.3).
•
Cleaning the electro valve filters (section 14.4)
•
Cleaning the dispenser (section 14.5)
14.2. Cleaning the washer
•
We recommend periodic cleaning of the outside of the washing machine. Use a damp cloth or sponge.
•
To remove traces of grease, use mild soap and rinse as required.
•
Never use abrasive products or tools that could scratch or damage the surface of the washing machine.
14.3. Cleaning the door seal
•
Use a damp cloth or sponge.
•
Be especially careful to remove traces of laundry products or pieces of fabric that could be caught
between the folds of the seal.
•
Never use abrasive products or tools that could cut or damage the seal.
14.4. Cleaning the electro valve filters
Tools required:
•
Disassembly of the fittings: Slip-joint pliers or pipe wrench diam. 1 in. (35 mm).
•
Disassembly of the filter supports: wrench 1 in. (34mm).
•
Disassembly of the filters: pliers.
Steps to follow
•
Disconnect and mechanically lock the external switch. Close and mechanically lock the manual water
inlet valves.
•
Check the temperature of the hot water inlet hose, so as to avoid the risk of burns.
•
Disassemble the fittings that connect the hoses to the washing machine.
•
Disassemble the filter supports.
•
Remove the filters from their housings and clean the filters with pressurised water. Place them back into
their housings.
•
Assemble the supports to the electrovalves.
•
Assemble the hoses in their corresponding inputs. Tighten the fittings.
•
Connect the external switch, open the manual water input valves and check the water tightness of the
coupling.
Maintenance
47
Cod. 429159
Rev. 01/0306