Unpacking The San768B-2; Attaching The Shelf Brackets - IBM SAN768B-2 User Manual

Unpacking the SAN768B-2

Attention: If the product needs to be transported a long distance, or if there are
uneven floors to cross, keep the product in its original packaging, and relocate the
entire shipment close to the installation location, using a pallet jack to lift and
move it.
To unpack the SAN768B-2, follow these steps:
1. Cut the bands that encircle the packaging.
2. Remove the lid, the 14U rack mount kit, the accessory kit, and the packing
3. Lift the cardboard box off the chassis and remove the plastic bag from around
4. Leave the chassis on top of the plastic shipping tray if the chassis must be
5. Use the lift tool to transport the new chassis to the installation area. Doorways

Attaching the shelf brackets

Rack mount kit parts list
The following parts list refers to items illustrated in Figure 3 on page 19. These
parts are used to install the SAN768B-2 into the C36 cabinet.
18
SAN768B-2 Installation, Service, and User Guide
foam from the top of the chassis. Set the kits aside for later use.
the chassis. Save the packing materials if you are returning an old chassis.
transported to the installation location.
Note: The standard packaging does not incorporate a wood pallet and pallet
brackets. The chassis sits on top of a plastic shipping tray.
must be wider than 91 cm (36 in.) to accommodate the chassis on the shipping
tray.
Table 4. Items supplied with the 14U rack mount kit
Item Description
For all types of installations
A Left rack mount shelf bracket (rail brackets may differ from the
illustration)
B Right rack mount shelf bracket (rail brackets may differ from the
illustration)
C 10-32 x 5/8 inch (1.58 cm) panhead Phillips screw, washer
For cabinets that have vertical rails with round holes
D 10-32 clip nut
E 1/4-20 x 1/2 in. (1.27 cm) panhead Phillips screw, with lock
washer
For cabinets that have vertical rails with square holes
F 10-32 retainer nut
G 1/4-20 x 1/2 in. (1.27 cm) panhead Phillips screw, with glue
H 0.375 in. (0.953 cm) alignment washer
Quantity
1
1
6
6
16
6
16
16