Tools; Configuration Settings - Patton SmartNode SN101/1JS/E User Manual

SmartNode 100 Series ATA User Manual
8. Optionally STUN may be configured, if the SN100 device is installed behind NAT.
9. Enter the STUN Server address
10. Specify the port for STUN. Default setting: 3478.
11. There might be a username and password required for STUN that is different from the ACS settings. If so,
type the STUN User Name and Password in the corresponding fields
12. For TR-069 connection requests, User Name and Password is to be configured as per figure 81
13. When you are satisfied with the settings, click the Apply button to save and apply the changes.
))

Tools

This section describes the following:
How to back up the SN100 configuration, restore a back up configuration, and reset the SN100 configura-
•
tion to factory default settings (see
• How to upgrade SN100 firmware (see
How to run a ping test to troubleshoot problems network problems (see
•
How to make the SN100 perform a software restart (see
•
page 130)

Configuration settings

This window enables you to do the following:
Back up current SN100 settings to a file
•
Restore settings from a previous backup file.
•
Reset the current configuration to factory default settings
•
Do the following to display tools configuration settings:
1. Click on the plus button next to Maintenance to display the sub-categories (see
2. Click Tools. The Configuration window displays (see

Tools

"Configuration settings"

"Reset the SN100 to factory default settings"
"Performing an SN100 software restart"
figure
8 • Maintenance Settings
on page 127).
"Running a Ping Test"
figure 76
82).
on page 129)
on page 130)
on
on page 120).
127