Table of Contents
Advertisement
SmartNode 100 Series ATA User Manual
If your ISP uses Layer 2 Tunneling Protocol (L2TP) to support virtual pri-
Note
vate networks (VPNs) or other services, go to section
page 57.
L2TP with WAN
Some ISPs use L2TP with static, DHCP, or PPPoE to establish communication links with end-users.
1. Type the L2TP server IP address: that was provided by your VPN /PPTP server provider
2. Type the L2TP user name (L2TP dial-in account)
3. Type the L2TP password (L2TP dial-in password)
4. Type the L2TP MTU size
5. If appropriate, click the Remote LAN setting check box to enable SIP Call by LAN IP Address
6. If appropriate, click the Remote LAN setting check box to enable SIP Call by LAN IP Address
7. Click the Apply button.
LAN Interface
Do the following to display LAN settings:
1. Click on the plus button next to Network to display the sub-categories (see
2. Click LAN. The LAN Setup window displays (see
LAN Interface
"L2TP with WAN"
figure 41
on page 54).
5 • Network Settings
on
figure 40
on page 54).
57
Hide quick links:
Advertisement
Table of Contents
