SmartNode 100 Series ATA User Manual
Connecting the ATA to a computer
1. Connect the one end of the yellow Ethernet cable included in the SN100 package to the LAN port on the
ATA. If you are connecting the ATA directly to a computer, go to step 2. Otherwise, go to step 4 to con-
nect multiple computers to the ATA via a hub, switch, or router.
2. Disconnect power from your computer.
3. Connect the other end of the Ethernet cable to your computer's network interface card (NIC).
4. Disconnect power from your hub, switch, or router.
5. Connect the other end of the Ethernet cable to your hub, switch, or router's WAN/Internet port.
6. Connect your computer(s) to the available hub, switch, or router LAN ports using separate Ethernet
cables.
Connecting the ATA to a cable/DSL modem or router
1. Connect one end of an Ethernet cable (with RJ-45 connectors) to the WAN port on the ATA.
2. Disconnect power from your cable/DSL modem or router.
3. Connect the other end of the Ethernet cable to a DSL/cable modem or router.
Connecting the ATA to telephones or fax machines
The two ATA FXS phone ports enable you to connect two analog telephones, two fax machines, or one tele-
phone and one fax machine to the ATA.
1. Connect an analog telephone or fax machine to the Phone1 port on the ATA.
2. Connect an analog telephone or fax machine to the Phone2 port on the ATA.
Connecting power to the ATA
1. Connect the power adapter's barrel jack to the Power port on the ATA.
2. Connect the other end of the power adapter to the AC power outlet.
3. Verify that the ATA's Power LED is lit.
4. Connect power to the computer or hub, switch, or router.
5. Connect power to the cable/DSL modem or router.
The ATA is installed. Proceed to Chapter 3,
Installing the SN102/1JS1JO/E (1 FXS port and 1 FXO ports) ATA
Installation consists of the following:
•
Verifying the package contents (see section
Connecting the ATA LAN port directly to a computer or to a computer via a switch/hub (see section
•
necting the ATA to a computer"
Connecting the ATA WAN port to a cable/DSL modem or router (see section
•
cable/DSL modem or router"
Installing the SN102/1JS1JO/E (1 FXS port and 1 FXO ports) ATA
"Quick Start"
"Package contents"
on page 27)
on page 27)
on page 29.
on page 27)
"Connecting the ATA to a
2 • Installation
"Con-
26