SmartNode 100 Series ATA User Manual
Connecting the ATA WAN port to a cable/DSL modem or router (see section
•
cable/DSL modem or router"
Connecting the ATA Phone port to an analog telephone or fax machine (see section
•
telephone or fax machine"
Connecting power to the ATA (see section
•
Package contents
SmartNode 100 Series ATA
•
Ethernet cable (Cat. 5, UTP, unshielded twisted pair, Color: yellow, RJ-45 connectors, Length 5 feet/1.5 m)
•
(see
figure
8)
Phone line cable (Color: gray, RJ-11 connectors, Length 5 feet/1.5 m)
•
Power adapter (12VDC/1A)
•
Connecting the ATA to a computer
1. Connect one end of the Ethernet cable included in the SN100 package to the LAN port on the ATA. If
you are connecting the ATA directly to a computer, go to step 2. Otherwise, go to step 4 to connect multi-
ple computers to the ATA via a hub, switch, or router.
2. Disconnect power from your computer.
3. Connect the other end of the Ethernet cable to your computer's network interface card (NIC). Go to sec-
tion
"Connecting the ATA to a cable/DSL modem or
4. Disconnect power from your hub, switch, or router.
5. Connect the other end of the Ethernet cable to your hub, switch, or router's WAN/Internet port.
Installing the SN101/1JS/E (1 FXS port) ATA
on page 25)
on page 25)
"Connecting power to the ATA"
Figure 8. SN100 ATA cables and 12VDC/1A power adapter
"Connecting the ATA to a
on page 25)
router".
2 • Installation
"Connecting the ATA to a
24