Dhcp Client; Pppoe - Patton SmartNode SN101/1JS/E User Manual

SmartNode 100 Series ATA User Manual
Do the following:
1. Type the IP address that was provided by your ISP.
2. Type the subnet mask that was provided by your ISP.
3. Type the default gateway address that was provided by your ISP.
4. Click the Apply button.
If your ISP uses Layer 2 Tunneling Protocol (L2TP) to support virtual pri-
Note
vate networks (VPNs) or other services, go to section
page 57.

DHCP client

When Dynamic Host Configuration Protocol (DHCP) Internet Protocol (Dynamic IP) is selected, the WAN
IP address, subnet mask, and default gateway IP address will be obtained automatically. If you are connected to
the Internet through a cable modem line, dynamic IP will be assigned.
If your ISP uses Layer 2 Tunneling Protocol (L2TP) to support virtual pri-
Note
vate networks (VPNs) or other services, go to section
page 57.

PPPoE

Some ISPs provide DSL-based services and use Point-to-Point Protocol over Ethernet (PPPoE) to establish
communication links with end-users. If you are connected to the Internet through a DSL line, check with your
ISP to see if they use PPPoE. If they do, you need to configure the following:
1. User name: Type the username provided by your ISP.
2. Password: Type the password provided by your ISP.
3. Click the Apply button.
WAN Interface
5 • Network Settings
"L2TP with WAN" on
"L2TP with WAN" on
56