SmartNode 100 Series ATA User Manual
Polarity Reversal settings (see section
•
•
Caller ID settings (see section
Hook-Flash Timing settings (see section
•
Hot Line settings (see section
•
Jitter Buffer Control settings.
gestion, timing drift, or route changes. The jitter buffer control is a shared data area where voice packets can be
stored, collected, and sent to the voice shared buffer in evenly spaced intervals.
Min delay (ms): Select minimum delay buffer time from the drop-down menu
•
Max delay (ms): Select maximum delay buffer time from the drop-down menu
•
When you are satisfied with the setting, click the Apply button to save and apply the changes.
))
Voice Activity Detection settings.
be sent across the network during that period in order to save bandwidth.
Click the check box to enable voice activity detection (VAD).
When you are satisfied with the setting, click the Apply button to save and apply the changes.
))
G.168 Echo cancellation settings.
When you are satisfied with the setting, click the Apply button to save and apply the changes.
))
Phone
"Polarity Reversal settings"
"Caller ID settings"
on page 104)
"Hook-Flash Timing settings"
"Hot Line settings"
on page 105)
Changes in packets arrival time, called jitter, can occur because of network con-
If this function is enabled, if silence occurs for a period of time, no data will
Select the LEC tail length (ms) from the drop-down menu.
on page 103)
on page 104)
6 • VoIP Settings
102