Package Contents; Connecting The Ata To A Computer; Connecting The Ata To A Cable/Dsl Modem Or Router; Connecting The Ata To A Telephone Or Fax Machine - Patton SmartNode SN101/1JS/E User Manual

SmartNode 100 Series ATA User Manual
Connecting the ATA Phone FXS port to an analog telephone or fax machine (see section
•
ATA to a telephone or fax machine"
Connecting the ATA Line FXO port to the PSTN or a PBX (see section
•
or a PBX" on page 27)
Connecting power to the ATA (see section
•

Package contents

SmartNode 100 Series ATA
•
Ethernet cable (Cat. 5, UTP, unshielded twisted pair, Color: yellow, RJ-45 connectors, Length 5 feet/1.5 m)
•
(see figure 8 on page 24)
Phone line cable (Color: gray, RJ-11 connectors, Length 5 feet./1.5 m)
•
Power adapter (12VDC/1A)
•

Connecting the ATA to a computer

1. Connect the one end of yellow Ethernet cable included in the SN100 package to the LAN port on the
ATA. If you are connecting the ATA directly to a computer, go to step 2. Otherwise, go to step 4 to con-
nect multiple computers to the ATA via a hub, switch, or router.
2. Disconnect power from your computer.
3. Connect the other end of the Ethernet cable to your computer's network interface card (NIC).
4. Disconnect power from your hub, switch, or router.
5. Connect the other end of the Ethernet cable to your hub, switch, or router's WAN/Internet port.
6. Connect your computer(s) to the available hub, switch, or router LAN ports using separate Ethernet
cables.

Connecting the ATA to a cable/DSL modem or router

1. Connect one end of an Ethernet cable (with RJ-45 connectors) to the WAN port on the ATA.
2. Disconnect power from your cable/DSL modem or router.
3. Connect the other end of the Ethernet cable to a DSL/cable modem or router.

Connecting the ATA to a telephone or fax machine

Using the included gray phone cable, connect your analog telephone or fax machine to the Phone port on the
ATA.

Connecting the ATA to the PSTN or a PBX

Connect the PSTN or a PBX to the Line port on the ATA.

Connecting power to the ATA

1. Connect the power adapter's barrel jack to the Power port on the ATA.
2. Connect the other end of the power adapter to the AC power outlet.
3. Verify that the ATA's Power LED is lit.
Installing the SN102/1JS1JO/E (1 FXS port and 1 FXO ports) ATA
on page 27)

"Connecting power to the ATA"

2 • Installation
"Connecting the
"Connecting the ATA to the PSTN
on page 27)
27