Common Window; Hot Line Settings; Pulse Dial Detection Settings - Patton SmartNode SN101/1JS/E User Manual

SmartNode 100 Series ATA User Manual
When you are satisfied with the setting, click the Apply button to save and apply the changes.
))
This service enables you to call a pre-programmed number simply by lifting the handset.

Hot Line settings.

The following settings are available:
Use Hot Line: Click the check box to enable the hot line service.
•
Hot Line Timer: This feature is typically used for setting up a hot line or warm line, with a 0-second timer
•
delay for the hot line and a non-zero delay for a warm line. Type the value in seconds.
• Hot Line Number: Input the number for the hot line service—This number will be called immediately when
the telephone goes off-hook.
d
When you are satisfied with the setting, click the Apply button to save and apply the changes.
))

Common window

The Common window displays the following;
Pulse Dial Detection settings (see section
•
Off-Hook Alarm settings (see section
•
DTMF Detection Threshold settings (see section
•

Pulse Dial Detection settings

1. Click to enable pulse dial detection if you are connecting a pulse (rotary) dialing telephone to the SN100.
z
2. Type the Interdigit Pause Duration value.
3. When you are satisfied with the settings, click the Apply button to save and apply the changes.
))
Phone
"Pulse Dial Detection settings"
"Off-Hook Alarm settings"
"DTMF Detection Threshold settings"
on page 105)
on page 106)
6 • VoIP Settings
on page 106)
105