Dial Termination Key; Session Timer; Mwi (Message Waiting Indication) - Patton SmartNode SN101/1JS/E User Manual

SmartNode 100 Series ATA User Manual 6 • VoIP Settings
When you are satisfied with the setting, click the Apply button to save and apply the changes.
))
Select enable if you want to use the pound (#) key to tell device to make the phone call

Dial Termination Key.

immediately.
When you are satisfied with the setting, click the Apply button to save and apply the changes.
))
Select Enable if you want to define how long the ATA waits to receive a session-alive packet for

Session Timer.

a voice session from the SIP server.
Minimum Expiration Time: Enter the minimum time the ATA waits for a session-alive packet (90-65536 sec-
onds). If a session-alive packet is not received during this time, the voice session is terminated.
When you are satisfied with the setting, click the Apply button to save and apply the changes.
))
Active: Select this if you want to hear a waiting (beeping) dial tone on

MWI (Message Waiting Indication).

your phone when you have at least one voice message. Your SIP service provider must support this feature.
Expiration Time: Keep the default value, unless your SIP service provider tells you to change it. Enter the num-
ber of seconds the SIP server should provide the message waiting service each time the ATA subscribes to the
service. Before this time passes, the ATA automatically subscribes again.
When you are satisfied with the setting, click the Apply button to save and apply the changes.
))
SIP 72