SmartNode 100 Series ATA User Manual
6. Connect your computer(s) to the available hub, switch, or router LAN ports using separate Ethernet
cables.
Connecting the ATA to a cable/DSL modem or router
1. Connect one end of an Ethernet cable (with RJ-45 connectors) to the WAN port on the ATA.
2. Disconnect power from your cable/DSL modem or router.
3. Connect the other end of the Ethernet cable to a DSL/cable modem or router.
Connecting the ATA to a telephone or fax machine
Connect your analog telephone or fax machine to the Phone port on the ATA.
Connecting power to the ATA
1. Connect the power adapter's barrel jack to the Power port on the ATA.
2. Connect the other end of the power adapter to the AC power outlet.
3. Verify that the ATA's Power LED is lit.
4. Connect power to the computer or hub, switch, or router.
5. Connect power to the cable/DSL modem or router.
The ATA is installed. Proceed to Chapter 3,
Installing the SN102/2JS/E (2 FXS ports) ATA
Installation consists of the following:
Verifying the package contents (see section
•
Connecting the ATA LAN port directly to a computer or to a computer via a switch/hub (see section
•
necting the ATA to a computer"
Connecting the ATA WAN port to a cable/DSL modem or router (see section
•
cable/DSL modem or router"
•
Connecting the ATA Phone1 and Phone2 ports to two analog telephones, two fax machines or one phone and
one fax machine (see section
Connecting power to the ATA (see section
•
Package contents
•
SmartNode 100 Series ATA
Ethernet cable (Cat. 5, UTP, unshielded twisted pair, Color: yellow, RJ-45 connectors, Length 5 feet/1.5 m)
•
(see
figure 8
on page 24)
•
Phone line cable (Color: gray, RJ-11 connectors, Length 5 feet/1.5 m)
Power adapter (12VDC/1A)
•
Installing the SN102/2JS/E (2 FXS ports) ATA
"Quick Start"
"Package contents"
on page 26)
on page 26)
"Connecting the ATA to telephones or fax machines"
"Connecting power to the ATA"
on page 29.
on page 25)
"Connecting the ATA to a
on page 26)
2 • Installation
"Con-
on page 26)
25