Table of Contents
Advertisement
SmartNode 100 Series ATA User Manual
Introduction
This chapter describes the following:
Configuring the System settings (see section "System")
•
Configuring the Tools settings (see section
•
•
Configuring Logs settings (see section
System
This section describes the following:
Configuring general system settings (see
•
Configuring Administrators Account's user name and password (see
•
user name and password"
Configuring User Account's user name and password (see
•
word"
on page 122)
•
Configuring time settings (see
Configuring auto-provisioning settings (see
•
Configuring dynamic DNS settings (see
•
•
Configuring TR069 settings (see
Configuring General System settings
This window is where you set router or bridge mode. In bridge mode, firewall and NAT functions are disabled,
which also means that there is no longer LAN IP addresses being assigned to devices connected to it. Accessing
the SN100 when in bridge mode, requires a static IP to be set on the device which is to be specified under
Manager IP Address as shown in
Do the following to display General settings:
1. Click on the plus button next to Maintenance to display the sub-categories (see
2. Click Maintenance. The Gemeral window displays (see
Introduction
"Tools"
"Logs"
on page 131)
"Configuring General System
on page 121)
"Configuring Time settings"
"Configuring Auto Provision settings"
"Configuring Dynamic DNS settings"
"Configuring TR069 settings"
figure 77
on page 121.
Figure 76. Maintenance sub-categories
on page 127)
settings")
"Configuring Administrator Account's
"Configuring User Account's user name and pass-
on page 122)
on page 125).
figure 77
on page 121).
8 • Maintenance Settings
on page 123)
on page 124)
figure
76).
120
Hide quick links:
Advertisement
Table of Contents
