Setting The Time Manually; Configuring Auto Provision Settings; Auto Provision Window - Patton SmartNode SN101/1JS/E User Manual

SmartNode 100 Series ATA User Manual
7. If you did not enable NTP client update, go to section
button next to the NTP server drop-down menu, then choose the desired NTP server from the menu. If
you want to manually enter the NTP server address, click the button next to the Manual IP Setting box,
then type the address (for example: 0.patton.pool.ntp.org).
8. When you are satisfied with the settings, click the Apply button to save and apply the changes.
))

Setting the time manually

If you wish to set the local time of the SN100 manually, in case there is no NTP server accessible from the net-
work where the device is being installed, do the following.
1. Uncheck the box for Enable NTP client update (see
2. Enter the date and time.
3. When you are satisfied with the settings, click the Apply button to save and apply the changes.
))

Configuring Auto Provision settings

The provisioning function may be used for an automated, mass configuration of SN100 CPEs in the field. The
provisioned configuration file, is loaded in to the system startup config once it has been downloaded. After the
download has been done, the device will reboot to apply the changes as per the new config file.
Do the following to set up auto-provisioning:
1. Click on the plus button next to Maintenance to display the sub-categories (see
2. Click System. The General window displays (see
3. Click the Auto Provision tab to bring it to the front (see
System
"Setting the time
figure 78
figure 77
figure 79
Figure 79. Auto Provision window
manually". Otherwise click the
on page 122).
figure 76
on page 121).
on page 123).
8 • Maintenance Settings
on page 120).
123