Caller Id Settings; Hook-Flash Timing Settings - Patton SmartNode SN101/1JS/E User Manual

SmartNode 100 Series ATA User Manual
d
The following settings are available:

Caller ID settings.

Caller ID Mode: Click the drop-down menu to select the caller ID mode.
•
• FSK Date & Time Sync: Click the check box to enable sending FSK date and time to the display device.
Reverse Polarity before Caller ID: Click the check box to enable sending reverse polarity before caller ID
•
Short Ring before Caller ID: Click the check box to enable sending a short ring before caller ID.
•
Dual Tone before Caller ID: Click the check box to enable sending dual tone before caller ID.
•
Caller ID Prior First Ring: Click the check box to enable sending caller ID before first ring.
•
Caller ID DTMF Start Digit: Click the drop-down menu to set the caller ID DTMF start digit.
•
Caller ID DTMF END Digit: Click the drop-down menu to set the caller ID DTMF end digit.
•
• Private Caller ID: A private caller has hidden or otherwise obfuscated their phone number. Often their number
displays as "Private Caller", "Restricted", "Unknown Caller ID" or "No Caller ID". Click the check box to
enable private caller ID.
When you are satisfied with the settings, click the Apply button to save and apply the changes.
))

Hook-Flash Timing settings.

ing up again (a quick off-hook/on-hook/off-hook cycle). This action can signal the telephone exchange to do
something. A common use of hook flash is to switch to another incoming call with the call waiting service.
Another use is to indicate a request for voice conferencing, for example, a user may use a procedure like the follow-
ing to initiate three-way calling.
The following settings are available:
Minimum on-hook time: Type the value (default is 30 ms)
•
Maximum on-hook time: Type the value (default is 2000 ms)
•
d
Phone
Hook-flash is a button on a telephone that simulates quickly hanging up then pick-
6 • VoIP Settings
104